Automatic Test
System for Personal RF Safety Monitor
This ATE
system calibrates and tests a personal RF safety monitor. A
simple pass/fail indicator is implemented allowing the use of
semi-skilled labor while a comprehensive data sheet provides
detailed performance information on each unit processed. All
test data is permanently stored for later analysis.[More]
4-Way, High Power
Microwave Switch / Combiner
Automatic test
and data analysis system for 4 way, microwave switch/combiner.
Utilization of this system has reduced test time from 39
minutes to 7 minutes (including operator touch time) resulting
in substantial cost savings. The simplicity of this ATE system
has enabled the company to switch from skilled RF test
technicians to offshore labor for additional savings. All test
data is permanently stored then transmitted via FTP to New York
for analysis.[More]
Cellular Antenna
Monitor / Spectrum Analyzer
Automatic test
and calibration system for 12 port, AMPS band antenna
monitor/spectrum analyzer. This system includes a fuzzy logic
controller (implemented in software) for accurate, high speed
targeting of calibration power levels. In addition, ATE was
developed for internal subassemblies and a suite of
"engineering tools" was created during initial product
development to speed up evaluation testing of initial product
design.
Switching Power
Supply
Automatic test
system for high speed testing of switching power supply
modules. Test time was reduced from 4 hours to under 2 minutes
per unit achieving profit goals and strict delivery deadlines.
This system incorporates a custom designed Over Voltage
Protection (OVP) test circuit and utilizes dynamic load testing
to assure spec. compliance over the full operational output
range.